Download Instructions:
- Click on a product. (The 'File
Download' dialogue-box will open)
- Select [Save this program to disk]
and click OK.
- Save the file on your Hard disk
drive.
Software installation on CompactFlash/SD:
If you download compressed software,
unzip the file before proceeding.
You
will have the .ASE file.
IMPORTANT:
Please check and ensure that there are
no other .ASE
files in the root directory (eg. E:\)
of the CompactFlash or SD with a minimum free space of 128MB.
- Copy the file on the root
directory (eg. E:\) of the
CompactFlash or SD disk, minimum free space 128Mb.
SETUP INSTRUCTIONS:
Once you have copied the file on your
CompactFlash/SD disk, follow the next steps:
- Insert the CompactFlash/SD cartridge
with the Software Update file in
the plotter and turn it
on.
- After a few seconds, the plotter
will request you to press the ENTER
key to start the update procedure.
- Press the ENTER key and wait until
the upload procedure is complete
(1-2 min.).
- A message will appear requesting
you to remove the CompactFlash/SD cartridge
out of the slot of the plotter.
NOTE: If the message does not
appear and the plotter does not restart
automatically, turn off the plotter
manually and then remove the Compact
Flash/SD.
- Once the cartridge is removed,
the new software will be installed
and the new features
will be available on the chartplotter.
- At this point you can insert the
chart cartridge and start up again.
*
These files DO NOT HAVE to be uncompressed.
(1)
Install this software version
ONLY after having updated
the BIOS of the instrument.
(2)
All routes, tracks and markers
present in the marine mode will
be lost if not previously saved
on Compact Flash/SD.
(3)
We strongly advise the use of
a
different Compact Flash/SD other
than the one you have with the
cartography files.
If this is not possible, REMEMBER TO
CANCEL ALL SOFTWARE UPDATE FILES (BIOS,
Land & Sea software files etc.)
after upgrading the plotter, otherwise
the plotter will conduct the software
update cycle, each time the plotter
is switched on.
ATTENTION!
If you wish to utilize the same
cartridge to update other chartplotters, DO
NOT insert it into
a plotter that has already been
updated
OR which is already powered on. |
