Download Instructions:
- Click on a product. (The 'File
Download' dialogue-box will open)
- Select [Save this program to disk]
and click OK.
- Save the file on your Hard disk
drive.
Software installation on CompactFlash/SD:
If you download compressed software,
unzip the file before proceeding.
You
will have the .ASE file.
IMPORTANT:
Please check and ensure that there are
no other .ASE
files in the root directory (eg. E:\)
of the CompactFlash/SD with a minimum free space of 128 MB.
- Copy the file on the root
directory (eg. E:\) of the
CompactFlash or SD disk, minimum free space 128Mb.
SETUP INSTRUCTIONS:
Once you have copied the file on your
CompactFlash or SD disk, follow the next steps:
- Insert the CompactFlash or the SD cartridge
with the Software Update file in
the plotter and turn it
on.
- After a few seconds, the plotter
will request you to press the ENTER
key to start the update procedure.
- Press the ENTER key and wait until
the upload procedure is complete
(1-2 min.).
- A message will appear requesting
you to remove the CompactFlash or the SD cartridge
out of the slot of the plotter.
NOTE: If the message does not
appear and the plotter does not restart
automatically, turn off the plotter
manually and then remove the compact
flash.
- Once the cartridge is removed,
the new software will be installed
and the new features
will be available on the chartplotter.
- At this point you can insert the
chart cartridge and start up again
*
These files DO NOT HAVE to be
uncompressed. (1)
Install this software version
ONLY after having updated the
BIOS of the instrument.
(2)
All routes, tracks and markers present in the marine mode will be lost if not
previously saved on Compact Flash.
(3)We strongly
advise the use of a different compact
flash other than the one you have
with the cartography files.
If this is not possible, REMEMBER
TO CANCEL ALL SOFTWARE UPDATE FILES
(BIOS,
Land & Sea software files etc.)
after upgrading the plotter, otherwise
the plotter will conduct the software
update cycle, each time the plotter
is switched on.
ATTENTION!
If you wish to utilize the same
cartridge to update other chartplotters, DO
NOT insert it into
a plotter that has already been
updated
OR which is already powered on. |
