Download Instructions:
- Click on a product. (The 'File
Download' dialogue-box will open)
- Select [Save this program to disk]
and click OK.
- Save the file on your Hard disk
drive.
Software installation on CompactFlash/SD:
If you download compressed software,
unzip the file before proceeding.
You
will have the .ASE file.
IMPORTANT:
Please check and ensure that there are
no other .ASE
files in the root directory (eg. E:\)
of the CompactFlash/SD with a minimum free space of 128 MB.
- Copy the file on the root
directory (eg. E:\) of the
CompactFlash or SD disk, minimum free space 128Mb.
SETUP INSTRUCTIONS:
Once you have copied the file on your
CompactFlash or SD disk, follow the next steps:
- Insert the CompactFlash or the SD cartridge
with the Software Update file in
the plotter and turn it
on.
- After a few seconds, the plotter
will request you to press the ENTER
key to start the update procedure.
- Press the ENTER key and wait until
the upload procedure is complete
(1-2 min.).
- A message will appear requesting
you to remove the CompactFlash or the SD cartridge
out of the slot of the plotter.
NOTE: If the message does not
appear and the plotter does not restart
automatically, turn off the plotter
manually and then remove the compact
flash.
- Once the cartridge is removed,
the new software will be installed
and the new features
will be available on the chartplotter.
- At this point you can insert the
chart cartridge and start up again
ATTENTION!
If you wish to utilize the same
cartridge to update other chartplotters, DO
NOT insert it into
a plotter that has already been
updated
OR which is already powered on. |
